Logo
Page 1 of 121 1231151101 ... LastLast
Threads 1 to 50 of 6001

Forum Home: Mercruiser Sterndrive Forum

Sub-Forums Threads / Posts  Last Post

  1. Forum Actions:

    Forum Statistics:

    • Threads: 6,299
    • Posts: 41,315
    • Replies: 7
    • Views: 25,215
    09-24-2017, 01:09 AM Go to last post
  1. OMC to BIII conversion mega thread

    Started by o2batsea, 02-11-2019 09:33 AM
    • Replies: 19
    • Views: 363
    Today, 07:55 AM Go to last post
  2. What spark plug wire to install?

    Started by Frenchman Bob, 03-18-2019 10:58 AM
    • Replies: 5
    • Views: 78
    Yesterday, 06:02 PM Go to last post
  3. Ignition problem

    Started by Markmas, 03-14-2019 02:55 PM
    • Replies: 13
    • Views: 121
    Yesterday, 02:17 PM Go to last post
  4. no water just steam.

    Started by peterrow, 03-16-2019 07:37 AM
    • Replies: 3
    • Views: 91
    Yesterday, 03:34 AM Go to last post
  5. 2004 4.3l Mercruiser no spark

    Started by gotten, 03-11-2019 06:40 PM
    • Replies: 8
    • Views: 122
    03-16-2019, 06:32 PM Go to last post
  6. Thumbs down 4.3L MPI surging when trying to rev or under load

    Started by sebbi69, 03-16-2019 12:27 AM
    • Replies: 1
    • Views: 39
    03-16-2019, 11:22 AM Go to last post
  7. Mercruiser 165 Stalling/dying Problems.

    Started by 78Glasply, 03-13-2019 09:56 PM
    • Replies: 9
    • Views: 117
    03-15-2019, 07:21 PM Go to last post
  8. 350MPI - Black Scorpion Base Engine?

    Started by 2000_Tige, 02-19-2019 02:47 PM
    • Replies: 25
    • Views: 513
    03-14-2019, 03:46 PM Go to last post
  9. 2013 260 HP No start Hot

    Started by Mike AVM, 03-13-2019 01:40 PM
    • Replies: 1
    • Views: 51
    03-13-2019, 06:24 PM Go to last post
  10. 5.0 to 5.7 EFI question

    Started by Kmrod, 03-11-2019 12:38 AM
    • Replies: 4
    • Views: 86
    03-11-2019, 01:11 PM Go to last post
  11. Mercruiser 4.3l mpi low rpm limit problems

    Started by EHS, 02-28-2019 07:58 AM
    • Replies: 13
    • Views: 175
    03-11-2019, 11:57 AM Go to last post
    • Replies: 5
    • Views: 105
    03-09-2019, 09:34 PM Go to last post
  12. What size of carb jets?

    Started by Frenchman Bob, 03-04-2019 04:12 PM
    • Replies: 25
    • Views: 278
    03-08-2019, 10:11 AM Go to last post
  13. choosing a new lower

    Started by richny02, 03-07-2019 11:35 AM
    • Replies: 6
    • Views: 123
    03-07-2019, 03:46 PM Go to last post
  14. Mercruiser 3.0 stern drive 2005

    Started by Pwood22, 03-05-2019 04:52 PM
    • Replies: 8
    • Views: 140
    03-07-2019, 03:40 AM Go to last post
  15. Riser gasket clarification please

    Started by rick3452, 03-06-2019 07:52 PM
    • Replies: 4
    • Views: 93
    03-06-2019, 09:48 PM Go to last post
  16. Where do my plug wires go?

    Started by Lou McGoldrick, 03-06-2019 11:40 AM
    • Replies: 2
    • Views: 100
    03-06-2019, 07:34 PM Go to last post
  17. looking for cam specs for a mid 90's 5.7 roller

    Started by stang32, 03-06-2019 08:58 AM
    • Replies: 2
    • Views: 83
    03-06-2019, 04:32 PM Go to last post
  18. what year is my mercruiser 3.0L

    Started by Lou McGoldrick, 03-04-2019 11:59 AM
    • Replies: 3
    • Views: 111
    03-04-2019, 07:14 PM Go to last post
  19. no drive

    Started by kunbarrie, 12-30-2018 08:26 PM
    • Replies: 18
    • Views: 684
    03-02-2019, 07:31 PM Go to last post
  20. Mercrusier V6 Gen + Flywheel

    Started by Steve480, 02-23-2019 08:42 PM
    • Replies: 2
    • Views: 153
    03-02-2019, 07:14 AM Go to last post
  21. Alpha one failed pressure test.

    Started by 805HD, 03-01-2019 03:31 PM
    • Replies: 11
    • Views: 125
    03-01-2019, 10:30 PM Go to last post
    • Replies: 15
    • Views: 650
    03-01-2019, 01:17 PM Go to last post
  22. Rear engine mounts

    Started by 805HD, 03-01-2019 01:50 AM
    • Replies: 2
    • Views: 111
    03-01-2019, 12:58 PM Go to last post
  23. charging trolling motor batteries on the water

    Started by GoodGrief, 03-13-2012 10:09 AM
    • Replies: 18
    • Views: 10,456
    02-23-2019, 01:49 AM Go to last post
  24. 2003 5.7 350 serpentine belt tension

    Started by abl1111, 04-17-2015 07:12 PM
    • Replies: 5
    • Views: 574
    02-22-2019, 05:47 PM Go to last post
  25. Correct Belt Tension

    Started by BroJames, 02-21-2019 09:22 AM
    • Replies: 9
    • Views: 163
    02-22-2019, 03:03 PM Go to last post
  26. Gen VI 454 valve cover tabs?

    Started by cscott, 02-19-2019 03:19 PM
    • Replies: 4
    • Views: 262
    02-20-2019, 05:48 PM Go to last post
  27. Are they studs in the transom shield?

    Started by mattryan, 02-19-2019 06:36 PM
    • Replies: 1
    • Views: 236
    02-20-2019, 05:49 AM Go to last post
    • Replies: 14
    • Views: 293
    02-18-2019, 11:57 AM Go to last post
  28. 2000 M/C 5.0 0m012817. Two cylinders not firing

    Started by rick3452, 02-04-2019 04:15 PM
    • Replies: 29
    • Views: 520
    02-17-2019, 09:12 PM Go to last post
  29. Bravo 3 gear set

    Started by RickParrott, 02-13-2019 10:13 AM
    • Replies: 14
    • Views: 345
    02-17-2019, 06:38 PM Go to last post
  30. Re-torquing heads - Mercruiser 7.4L

    Started by rnace, 02-12-2019 11:53 PM
    • Replies: 3
    • Views: 283
    02-16-2019, 07:42 AM Go to last post
  31. shot impeller?...plastic bag overheating

    Started by Pluterday, 12-23-2018 07:02 AM
    • Replies: 13
    • Views: 621
    02-15-2019, 06:33 PM Go to last post
  32. Post Throttle Control Replacement - Help Me Choose!

    Started by kloos1502, 01-31-2019 09:54 PM
    2 Pages
    1 2
    • Replies: 35
    • Views: 826
    02-15-2019, 02:54 PM Go to last post
  33. Quicksilver OEM Mercruiser flushing kit ?

    Started by Pluterday, 02-13-2019 11:08 PM
    • Replies: 6
    • Views: 233
    02-15-2019, 07:59 AM Go to last post
  34. Install O-RING or don't install O-RING

    Started by trimta, 02-11-2019 07:36 PM
    • Replies: 3
    • Views: 241
    02-12-2019, 05:37 AM Go to last post
  35. Preferred Mercarb base gasket for 3.0 LX

    Started by jon_allen, 05-30-2018 10:21 AM
    • Replies: 3
    • Views: 339
    02-09-2019, 06:18 PM Go to last post
  36. NO serial numbers?

    Started by trimta, 11-20-2018 06:39 PM
    • Replies: 12
    • Views: 721
    02-08-2019, 06:50 PM Go to last post
  37. Throttle body to carburetor conversion

    Started by MahoganyJohn, 01-31-2019 08:03 PM
    • Replies: 18
    • Views: 469
    02-08-2019, 02:00 PM Go to last post
  38. Gimbal bearing or u joint

    Started by Bba2, 02-06-2019 07:02 PM
    • Replies: 3
    • Views: 224
    02-07-2019, 07:20 AM Go to last post
  39. Coupler zerk

    Started by Mark S., 02-02-2019 10:07 PM
    • Replies: 6
    • Views: 281
    02-04-2019, 08:37 AM Go to last post
    • Replies: 20
    • Views: 10,674
    01-30-2019, 07:24 AM Go to last post
  40. 1999 4.3 with cracked block or head

    Started by mike.l, 10-11-2018 07:32 PM
    • Replies: 22
    • Views: 1,013
    01-25-2019, 05:53 PM Go to last post
  41. Leaking transom after service.

    Started by mattryan, 01-17-2019 03:46 PM
    • Replies: 18
    • Views: 520
    01-24-2019, 08:20 AM Go to last post
  42. 3.0 mercruiser engine

    Started by Tim in MT, 01-22-2019 09:04 PM
    • Replies: 5
    • Views: 315
    01-23-2019, 08:50 PM Go to last post
  43. Manifolds and Risers

    Started by Jakwi, 01-22-2019 10:27 AM
    • Replies: 4
    • Views: 304
    01-22-2019, 12:45 PM Go to last post
    • Replies: 7
    • Views: 308
    01-17-2019, 04:42 AM Go to last post
    • Replies: 6
    • Views: 470
    01-15-2019, 12:40 PM Go to last post

Page 1 of 121 1231151101 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 10 replies or 100 views
Hot thread with unread posts
More than 10 replies or 100 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •