Logo
Page 1 of 8 123 ... LastLast
Threads 1 to 50 of 383

Forum Home: Yanmar

  1. Yanmar 4 cylinder 170 HP

    Started by "N, Hochschilkd", 09-10-2006 08:38 PM
    • Replies: 1
    • Views: 2,024
    09-27-2006, 05:55 PM Go to last post
  2. It wonbt stop

    Started by 6thdude, 04-28-2008 03:10 PM
    • Replies: 1
    • Views: 319
    07-19-2008, 06:07 AM Go to last post
  3. Prop size

    Started by able, 10-06-2009 03:11 PM
    • Replies: 3
    • Views: 470
    10-14-2009, 06:11 PM Go to last post
  4. Unhappy 3156LPSTP BROKEN CRANK SHAFT @ 708hrs

    Started by Absolom, 10-30-2011 08:33 AM
    • Replies: 1
    • Views: 1,559
    11-17-2011, 05:16 PM Go to last post
  5. Introduction to the 3GM30F

    Started by ace_2, 03-08-2009 11:36 AM
    • Replies: 0
    • Views: 336
    03-08-2009, 11:36 AM Go to last post
  6. Yanmar Serial Numbers

    Started by Adam Hkey, 06-16-2006 10:15 PM
    • Replies: 2
    • Views: 4,083
    05-15-2009, 08:52 PM Go to last post
    • Replies: 3
    • Views: 1,571
    11-18-2010, 06:12 PM Go to last post
    • Replies: 0
    • Views: 995
    01-27-2010, 07:06 PM Go to last post
  7. Yanmar 3LM engine

    Started by Adel, 02-16-2011 09:35 AM
    • Replies: 3
    • Views: 1,849
    02-21-2011, 09:59 AM Go to last post
  8. Yanmar 6LY 2AP 440HP High Oil Pressure

    Started by Al Ebstein, 12-20-2007 01:36 PM
    • Replies: 2
    • Views: 1,515
    12-21-2007, 10:50 PM Go to last post
    • Replies: 1
    • Views: 1,894
    01-10-2012, 05:26 PM Go to last post
  9. Decompression levers

    Started by Alcyone, 06-08-2012 12:30 PM
    • Replies: 0
    • Views: 1,617
    06-08-2012, 12:30 PM Go to last post
  10. Black smoke low RPMbs

    Started by alexe, 02-22-2010 10:34 AM
    • Replies: 2
    • Views: 546
    03-01-2010, 03:44 PM Go to last post
  11. Yanmar engine smoking 2005 140

    Started by Alfred11, 03-01-2011 02:18 PM
    • Replies: 2
    • Views: 1,282
    03-02-2011, 02:47 AM Go to last post
  12. Yanmar 6LP hole in head water jacket

    Started by aliboy, 02-09-2016 03:23 AM
    • Replies: 0
    • Views: 19,697
    02-09-2016, 03:23 AM Go to last post
  13. YSE8 vs YSE 12 motorbed

    Started by Alpis, 07-28-2017 01:58 PM
    • Replies: 1
    • Views: 873
    07-29-2017, 06:25 PM Go to last post
  14. Yanmar 3GM 30F injector pump

    Started by Andy in Asia, 07-19-2008 04:31 AM
    • Replies: 0
    • Views: 1,971
    07-19-2008, 04:31 AM Go to last post
  15. Yanmar1gm10

    Started by andybuk8, 12-01-2007 02:17 PM
    • Replies: 3
    • Views: 355
    03-11-2008, 02:33 PM Go to last post
  16. Engine will start but not stay cranked up

    Started by Anthony Locke, 04-23-2006 02:56 PM
    • Replies: 2
    • Views: 1,068
    08-30-2017, 05:03 PM Go to last post
  17. Where can i buy 1GM10 air box?

    Started by areajdm, 05-21-2010 04:17 AM
    • Replies: 1
    • Views: 960
    04-20-2011, 08:58 PM Go to last post
  18. Rocker Arm Assembly

    Started by Aries Quest, 06-14-2017 12:46 AM
    • Replies: 0
    • Views: 1,137
    06-14-2017, 12:46 AM Go to last post
  19. yanmar 6LP STE cracked cylinder head

    Started by arifaat, 03-14-2018 05:15 AM
    • Replies: 1
    • Views: 779
    03-19-2018, 04:34 AM Go to last post
  20. Kanzaki KM4A timing marks

    Started by arnon, 05-10-2008 11:23 AM
    • Replies: 2
    • Views: 1,283
    07-01-2008, 08:48 PM Go to last post
  21. Additive needed to control moisture in diesel fuel?

    Started by atea, 03-26-2010 01:49 PM
    • Replies: 3
    • Views: 1,161
    04-01-2010, 06:58 PM Go to last post
  22. Should boat tach be checked with hand-held tach?

    Started by atea, 05-15-2010 10:32 AM
    • Replies: 2
    • Views: 1,172
    05-29-2010, 05:56 PM Go to last post
    • Replies: 1
    • Views: 2,200
    10-26-2010, 07:36 AM Go to last post
  23. Yanmar 2GM20F Compression Check

    Started by barnaclebobby, 10-21-2007 02:18 PM
    • Replies: 14
    • Views: 10,251
    08-14-2010, 09:14 PM Go to last post
  24. Question Yanmar 3HM35F Injection Pump

    Started by Benjamin Harris, 09-27-2012 07:31 AM
    • Replies: 0
    • Views: 1,566
    09-27-2012, 07:31 AM Go to last post
  25. Yanmar 1GM10 propeller choice

    Started by bentuppen, 02-23-2010 06:20 AM
    • Replies: 1
    • Views: 2,549
    02-23-2010, 06:45 AM Go to last post
  26. yanmar 2gm20 loss of rpm underway

    Started by bill nichols, 06-27-2010 07:42 AM
    • Replies: 0
    • Views: 1,605
    06-27-2010, 07:42 AM Go to last post
  27. Yanmar 3GM30F

    Started by birddog29, 08-26-2008 04:35 PM
    • Replies: 1
    • Views: 1,174
    08-26-2008, 08:50 PM Go to last post
  28. Yanmar Underwater

    Started by BMc, 08-19-2013 12:47 PM
    • Replies: 4
    • Views: 1,114
    09-03-2013, 05:31 PM Go to last post
  29. FUEL INJECTOR LEAK AT OUTSIDE BASE

    Started by boatsailor64, 08-18-2009 11:19 PM
    • Replies: 1
    • Views: 746
    08-19-2009, 08:56 AM Go to last post
  30. Gear ratio

    Started by Bob 901, 09-30-2006 11:19 AM
    • Replies: 4
    • Views: 487
    10-04-2006, 10:51 AM Go to last post
  31. Hard starting after sitting 8 hp

    Started by Bob Gruen, 09-29-2007 05:44 PM
    • Replies: 1
    • Views: 332
    09-30-2007, 07:29 AM Go to last post
  32. Sea Water Pump Rebuild on Yanmar 3JH2E

    Started by Brad C, 06-18-2013 11:05 PM
    • Replies: 0
    • Views: 1,500
    06-18-2013, 11:05 PM Go to last post
  33. Sd 20 sail drive What prop

    Started by brian murphy, 04-13-2007 06:30 AM
    • Replies: 1
    • Views: 762
    04-13-2007, 06:32 AM Go to last post
  34. How to bleed air from a 2QM15 Bosch Injector pump

    Started by broggerp, 10-08-2007 01:00 PM
    • Replies: 5
    • Views: 3,297
    10-19-2007, 11:59 AM Go to last post
  35. Yanmar 3gm30 with stuck trottle

    Started by bubbabill, 01-07-2010 09:38 AM
    • Replies: 7
    • Views: 622
    01-18-2010, 08:13 PM Go to last post
  36. low power lots of black smoke 4jh2m-ute

    Started by buick430, 12-21-2011 03:20 AM
    • Replies: 6
    • Views: 2,333
    05-22-2012, 07:42 PM Go to last post
  37. "Yanmar 6LYA-STP - Oil in exhaust

    Started by bulit7, 06-11-2011 03:44 PM
    • Replies: 0
    • Views: 1,372
    06-11-2011, 03:44 PM Go to last post
  38. Smoke from Intake on Yanmar 3HMFX

    Started by burtonlangille, 07-03-2003 05:44 PM
    • Replies: 2
    • Views: 454
    03-20-2004, 04:43 PM Go to last post
  39. Alarm Turn Off on 6LY3

    Started by bwsouthworth, 03-28-2010 03:42 PM
    • Replies: 1
    • Views: 518
    03-29-2010, 04:26 PM Go to last post
  40. Saildrive upper seal leaking oil

    Started by C. Keijser, 08-07-2007 11:01 AM
    • Replies: 0
    • Views: 787
    08-07-2007, 11:01 AM Go to last post
  41. Blow By ?

    Started by capjules, 07-09-2015 04:11 PM
    • Replies: 0
    • Views: 1,259
    07-09-2015, 04:11 PM Go to last post
  42. Yanmar Parts

    Started by Capt. Keys, 05-03-2017 12:41 PM
    • Replies: 1
    • Views: 4,951
    05-03-2017, 10:05 PM Go to last post
  43. Yanmar 1gm seized after winterizing

    Started by Captain Ribeye, 03-24-2017 07:39 PM
    • Replies: 0
    • Views: 7,176
    03-24-2017, 07:39 PM Go to last post
    • Replies: 2
    • Views: 4,838
    04-09-2017, 06:20 AM Go to last post
  44. Yanmar 2QM15 overheats

    Started by captain_alex, 10-24-2008 05:34 PM
    • Replies: 2
    • Views: 878
    10-24-2008, 10:30 PM Go to last post
  45. 4JH2E Diesel vacuum gauge a blur

    Started by captnorm, 12-29-2007 05:02 PM
    • Replies: 1
    • Views: 528
    01-03-2008, 12:14 AM Go to last post

Page 1 of 8 123 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 10 replies or 100 views
Hot thread with unread posts
More than 10 replies or 100 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •