My mid shaft bushing was almost as tore up as yours, I think its the corrosion that forms next to the rubber on the bushing that eats away the aluminum.
123jayyyy Today, 01:13 AMIf you do have an eroded water tube grommet surface I have reliably repaired a couple using epoxy and it worked well. It's not easy and the powerhead
jgmo Today, 12:59 AMHello all,
Have a 95’ Johnson 2 stroke still with VRO working. Model J60TTLEO. Engine has always been a little finicky getting started when cold
Well....if you installed the water pump correctly and you didn't dislodge the drive key (which is easily done sometimes btw) then my guess is that that
jgmo Today, 12:45 AM
Re: BF225a4 - Flush Port Problems - What is this Allen Bolt?
I had a blockage in my flush port from grounding on a mud flat, I ran the motor on muffs while running water in the flush port and the mud finally broke
123jayyyy Today, 01:20 AM