• Engine and Drive Repair Topics

    by Published on 12-05-2011 07:34 PM
    Article Preview

    Winter Checklist

    • Stabilize fuel, then fill fuel tank. A full tank prevents water
      condensation from getting in tank and causing corrosion. Draining fuel
      does not prevent varnish formation in engines as fuel is left behind in the
      fuel system. Run engine for a few minutes to get treated gas throughout system.
    ...
    by Published on 10-02-2011 02:36 PM
    Article Preview

    A question we are often asked is "which is better… OEM or Aftermarket parts?"

    When you take your boat to the dealership's service department for repairs you're probably getting Original Equipment Manufacturer (OEM) engine parts. However, if you take your boat to an independent shop, you'll most likely get aftermarket parts. Is there anything wrong with that? Does a less expensive part mean ...
    Article Preview

    Reversible Tilt Trim Motors

    Today’s tilt-trim motors use wire wound or permanent magnet fields. Before you can accurately test the motor you must know what type it is.

    Wire wound field motors will normally have three wires and will usually have four screws placed around the
    perimeter of the motor case. If the motor has only two wires; it is usually a permanent magnet field motor.
    However, some older Mercury Marine wire wound field ...
    Article Preview

    Water intrusion is the #1 cause of starter failure. If water gets pumped into the motor portion of the starter from the flywheel, it will not drain out. Rust and corrosion will destroy the inside components of the starter.

    The #2 cause of starter failure ...
    Article Preview

    POINTS TO REMEMBER
    The battery is the heart of the electrical system. Always start troubleshooting at the battery. Never store a battery in a discharged state. Never add anything except distilled water to a battery.

    IMPORTANT BATTERY FACTS
    A good battery can provide four or five years of worry-free service with the right kind of care. Bigger is better! The battery you are replacing does not have to be the same size as the original. It is always better to have extra battery capacity. ...
    Article Preview

    ENGINE HORSEPOWER REQUIRED FOR ALTERNATORS
    For every 23 AMPS of alternator output about one horsepower is required.
    FOR EXAMPLE: A 12 volt,115 AMP alternator requires 5 horsepower.
    (115 divided by 23 = 5 horsepower). A 24 volt unit requires twice the horsepower.

    ALTERNATORS ARE NOT BATTERY CHARGERS
    Alternators are designed to supply current for the accessory load and maintain the charge of the ...
    Article Preview

    Safety Modifications

    Electrical systems[3]
    • Marine starter motor — it has an internal screen to minimize the egression of spark movements.
    • Marine alternator differs from an automobile alternator — it has an internal screen to minimize the egression
    ...

  • Recent Forum Posts

    joereeves

    Re: Evinrude 50 hp stalls at idle

    The engine running normally at high speed indicates that the high speed jets are clean and no problem exists there, and fuel must flow thru that jet before

    joereeves Today, 09:35 AM Go to last post
    RicardoMarine

    Re: 350MPI - Black Scorpion Base Engine?

    Scott, a few things to note:

    While some of the Merc (OEM) parts may no longer be available, correct replacement parts will indeed be available

    RicardoMarine Today, 08:44 AM Go to last post
    Sponz

    Old honda

    I,ve got an old Honda outboard model B100L, serial number 1704488. Any idea what year this is?

    Sponz Today, 08:41 AM Go to last post
    dappamikes

    Re: 50 hp force power pack

    Hey thanks for taking the time the time out to put this list together for me. Am sure someone else will also benefit from this. I will do my best to do

    dappamikes Today, 07:47 AM Go to last post
    scalhoun506

    Re: Evinrude 50 hp stalls at idle

    the idle circuit in the carb. may need cleaning, the core plug (small silver disk) on top of carb is removed and a couple of very small holes under it

    scalhoun506 Today, 07:46 AM Go to last post