Had a short in my wiring harness that went from ignition switch to the engine. It was fried from end to end. Cut through the decking and replaced. I’m
Why the doubts? Disconnect the 115TLRB (control cables, fuel hose, ten pin harness, battery cables, trim/oil harness if installed, etc.)
I am desperately searching for a carburetor for a Honda BFA75 outboard motor. The carburetor has been discontinued. Any leads on finding one would be
Has water pump impeller been replaced recently ?-----Overheat warning light tested ?------How much end play on the crankshaft ?-----Or can you lift flywheel
Take a very good look at the operation of the float and float valve.-----I think you might have problems elsewhere.
Browse Sections
Recent Forum Posts
