Check out this helpful video with tips on how to properly drain and refill the gear lube of your boats stern drive unit. And while you're here, take a look at the boat gear case lubes and tools we have available.
One last desperate attempt to assist you.----Fact !!--- I looked at a block.----I had a piston like that in my hands a minute ago.----Picture in post
racerone Today, 08:44 AMwildebeest - yeah, that occurred to me too - now I'm definitely gonna try a different tub w/ more/higher water - thanks!
RogueWave Today, 08:31 AMIf you're not getting any water pressure and no pee stream while running the motor in the tub, I suspect you are actually overheating and it's not a sensor
wildebeest Today, 08:18 AMFixed. Saw a video on replacing rope where they wound the spring/recoil up tight then held it there and installed the rope. This solved my issue although
ML_MCM Today, 07:47 AMShoot sorry wrong picture the piston is now flipped from what is in the photo. The two ports shown are now on the bottom lining up with the bottom two.
CCH Today, 07:40 AM