• Boat Docking Knowledge Video

    Boat Docking Knowledge Video from DiscoverBOATING

  • Recent Forum Posts

    timguy

    Re: New guy here, first boat, many questions.

    You can use as is but your prop now has very little protection. As it is more exposed a rock strike could more likely bend the prop shaft. A GOOD EXPERIENCED

    timguy Today, 08:50 PM Go to last post
    RicardoMarine

    Re: 290 sp rebuild

    If you have the red 1 pc Flywheel Cover (bell housing in the auto world) and with a grease fitting at the 12:00 O'clock position........ or, if you have

    RicardoMarine Today, 08:31 PM Go to last post
    RicardoMarine

    Re: 290 serial number

    Remove the propeller, remove the ring anode and wire brush the AFT end on the prop shaft bearing carrier.
    The numbers 1.61 should be stamped into

    RicardoMarine Today, 08:26 PM Go to last post
    Loafty

    Re: Mercury 50hp 2 stroke.

    Been looking everywhere on net for clip which shows exact motor but can't find one anywhere worse luck. What area do yu live on just in case struck trouble

    Loafty Today, 08:22 PM Go to last post
    Slipperyd12

    Re: 40 hp Mariner Tilt/Trim problem

    Looks like I found the problem. The manual release teflon was broken off down near the tip.
    So far it works fine. Thanks to everyone who helped.

    Slipperyd12 Today, 08:11 PM Go to last post