Logo
FULL SITE MENU

Motor mounts

T

torqueone

New member
I had found both of my motor m

I had found both of my motor mount bolts. The ones holding bell housing to transom very rusty and sheared most of the way through. I ordered 2 new ones that have springs and sleeves and large rubber washers that the old bolts didn’t seem to have. I imagine that is why they sheared. My question is does anyone have a diagram or instruction sheet of where all these parts fit?
 
"The fiber washer or leather a

"The fiber washer or leather as I call it, encircles the heavy spring washer. These go between the rear transom plate horns and the bellhousing. The 1/2" long thick spacer goes on top of the bellhousing motor mount,then the big flat washer, lock washer and the bolt goes thru it all."
 
Back
Top