Logo
FULL SITE MENU

Boat Exhaust

J

Joe Dirt

Guest
"I am running thur hull exhaus

"I am running thur hull exhaust, could I use abs, pvc, or cast iron to convert it back to it's regular exhaust? please let me know."
 
"Joe, You do not say what moto

"Joe, You do not say what motor you have, but the standard setup for a vee engine was to have the risers connect via rubber tube to aluminum elbows which directed the exhaust down thru another set of rubber tubes into the y-pipe which connected to the outdrive plate inside the boat. If you have the y-pipe, you should be able to install the rest of the stuff easily."
 
"Joe; if noise is an issue, yo

"Joe; if noise is an issue, you can likely get slip-in silencers to knock off some db. Otherwise you will have to pull the drive leg and the motor out to re-install the Y pipe. Big job.
Rod"
 
"all of it is still there, jus

"all of it is still there, just looking for a cheaper way to pipe it back from the riser to the y pipe"
 
Back
Top