Logo

30 cobra newbie

hadaveha

New member
"i have a 1988 3.0 cobra we ju

"i have a 1988 3.0 cobra we just did a engine change and runs great, but i have 2 questions 1 is before the engine swap trim worked great so after the swap we trimed the outdrive all the way up to move the boat, no the trim only clicks going up or down, and question 2 is when u put it in gear foward or rev. we get alot of loud slapping from the lower end of the out drive anyone ever run into ether of these problems.
thnks david"
 
"1) You must have Knocked

"1) You must have Knocked a Wire Loose or Something....

2) It Sounds like the lower Shift Cable Didn't get put back in, or Adjusted Right......."
 
is that one big clunk? (sl

is that one big clunk? (slap) Make sure You plugged the motor in.(large plug @ stbd rear of engine/ #10 blue and green wies)
 
Back
Top