Reveiwing these boards I see
Reveiwing these boards I see alot of knowledgeable people. I have a 200hp 1989 Johnson. WhenI try and put it in reverse it sometimes comes out and sounds like the gears are not properly engaging clinking sound. I tried adjusting cable but is already back all the way. I removed the lower unit shift rod is properly sized 26 16/16 from gearcase to middle of hole. I was was told it may be the clutch dog. Is this a difficult job and do I need special tools? How much would this repair cost and is there any other things I should get replaced while I am getting this work done?
Reveiwing these boards I see alot of knowledgeable people. I have a 200hp 1989 Johnson. WhenI try and put it in reverse it sometimes comes out and sounds like the gears are not properly engaging clinking sound. I tried adjusting cable but is already back all the way. I removed the lower unit shift rod is properly sized 26 16/16 from gearcase to middle of hole. I was was told it may be the clutch dog. Is this a difficult job and do I need special tools? How much would this repair cost and is there any other things I should get replaced while I am getting this work done?