I am in the process of rebuil
I am in the process of rebuilding my carbs on my 1983 80hp merc. Everything went well now I need to adjust the floats. The old floats were that spongy looking material. The new floats are a little smaller & made of plastic. I can't figure out the adjustement diagram. It says it should be between .660 & .690 but from what surface to what surface If anyone knows where to measure from & what it should measure I would greatly appreciate it.
I am in the process of rebuilding my carbs on my 1983 80hp merc. Everything went well now I need to adjust the floats. The old floats were that spongy looking material. The new floats are a little smaller & made of plastic. I can't figure out the adjustement diagram. It says it should be between .660 & .690 but from what surface to what surface If anyone knows where to measure from & what it should measure I would greatly appreciate it.