Logo

Kill Switch on 8HP Johnson

robbo

New member
" Hi Joe,

The leg was repla


" Hi Joe,

The leg was replaced on my 8HP Johnson. Since then, the kill switch will not stop the engine. I need to cut the fuel supply to stop. I assume it has something to do with the ignition wiring, or the switch itself. How should I proceed? "
 
"Robbo..... Replacing the lowe

"Robbo..... Replacing the lower unit has nothing to do with a kill switch. A kill switch has two wires, one leads to ground, the other leads to the "Black/Yellow" wire of the powerpack. I would assume that somehow one of those wires is either disconnected or broken.

Joe
"
 
Back
Top