C
contentkc
Guest
"Just went through and rebuilt
"Just went through and rebuilt,head job, new liners, pistons, rings. Guaged the pistons to pull @ 5/1000's. Polished the crank, & new bearings. Put it back to gether, started great, ran @ 180 degrees for 45 min. put it into gear and ran @ 1600 rpm, then reverse. Everything worked great. Put it back into forward gear and slowed the throttle and it ground to a stop. Pulled everything out and there is a little scaring on #4, but nothing major, any ideas, thanks"
"Just went through and rebuilt,head job, new liners, pistons, rings. Guaged the pistons to pull @ 5/1000's. Polished the crank, & new bearings. Put it back to gether, started great, ran @ 180 degrees for 45 min. put it into gear and ran @ 1600 rpm, then reverse. Everything worked great. Put it back into forward gear and slowed the throttle and it ground to a stop. Pulled everything out and there is a little scaring on #4, but nothing major, any ideas, thanks"