View Full Version : Bukh dv20 conrod orientation

05-16-2020, 04:01 AM
Hi all,
I recently disassembled the engine to install new rings. Now ready to put back together but stuck on which way rods should attach to crank. I noted which rod belongs to which cylinder but did not note which side of the engine the numbers on the rods faced. I assumed this detail would be in the service manual but alas it is not. The rods appear symmetrical so maybe it doesn't matter. I am using the same big end bearings as they are still very good. I would be grateful if anyone could guide me on this point.