HI folks I hope this is not a redundant question. I recently replaced the water pump impeller and gaskets in my 1986 200 since it was running hot at slow speeds.I pulled the thermostats and poppit valve and checked all the passages for flow/obstructions with compressed air and garden hose. I have great flow thoughout, when I shoot the hose up the tube coming from the water pump with the lower unit removed I get great flow out of both thermostat housings /poppit housing and telltale. After reassembling and running on the earmuffs water I have no flow to the top of the engine. Disassembled again and checked the impeller and key all seems assembled ok. The 2 gaskets were identical to the old ones. Any ideas? Thank you, Todd
Home
Outboard Motor Parts
Chrysler outboard parts Evinrude outboard parts Force outboard parts Honda outboard parts Johnson outboard parts Mariner outboard parts Mercury outboard parts Suzuki outboard parts Tohatsu outboard parts Yamaha outboard partsInboard & Sterndrive Engine Parts
Chrysler Marine inboard parts Crusader Marine parts MerCruiser sterndrive parts OMC sterndrive parts Pleasurecraft Marine parts Volvo Penta marine parts + MoreAll Engine Brands
All Manuals HomeOutboard Repair Manuals
Chrysler outboard manuals Evinrude outboard manuals Force outboard manuals Honda outboard manuals Johnson outboard manuals Mariner outboard manualsMercury outboard manuals Nissan outboard manuals Suzuki outboard manuals Tohatsu outboard manuals Yamaha outboard manuals
Inboard & Sterndrive Engine Manuals
MerCruiser sterndrive manuals OMC sterndrive manuals Volvo Penta marine engine manualsPlease Note
MarineEngine.com does not offer troubleshooting assistance or repair advice by email or by telephone.
You are invited to join our public Boat Repair Forum to seek assistance from other members.
You may also visit the Boat Motor Manuals section of our site to obtain a service manual.