Rebuilding a 10-18-004 unit because of slightly warped clutches. I have it almost broken down while I wait for parts. The manual looks good for the rebuild part but there's nothing about the tear down. I found a guy who posted some pics for another VD rebuild and they have been dead on until this step. His directions say remove "two snap rings" and then the center section pulls out of the drum. I removed the two on one end and the big one on the opposite end (they are oriented in the picture that way). How do I get these separated? I think that's my last step and I'll have all the clutches out.
http://i1170.photobucket.com/albums/r537/A8CT/image-1.jpg
thanks
Bob
http://i1170.photobucket.com/albums/r537/A8CT/image-1.jpg
thanks
Bob