Logo

1994 115 evinrude

to disconnect vro is a very simple process.
there is video of this on youtube that makes it look harder than it realy is,
but anyway here it is
take the oil pipe off at the fuel fitting on side of engine cowling on both sides .
on the inside plug the oil pipe so no air or dirt goes up to the oil side of the pump.
(some people cut the pipe 2 inches long on outside and just plug it there,but this looks horrible to me)
disconnect the electrical connectors for the vro under the cowling of engine and wrap them in tape etc to keep dry etc.
take the electrical lead back to vro tank and wrap that up as well.
Now just mix the petrol and 2 stroke oil at 50 to 1 ratio in the tank and yor good to go.
the first time you start up do not rev it for atleast 30 seconds, then once the new fuel gets in and around youl be fine.

if you need anything else or wire colours i can get you pics if needed

hope this helps


phill
 
Back
Top