Hello everyone. I am doing a lower unit reseal on my 1989 30 e30rced.
This has the shift shaft under the intake screens.
I see there is a special puller to pull the shift shaft bushing and the o-rings that go with it.
I assume there is a cast or machined shoulder down there so everything must be pulled up? The manual calls for tool handle part # 327693
Does anyone know what diameter the puller end should be?
This has the shift shaft under the intake screens.
I see there is a special puller to pull the shift shaft bushing and the o-rings that go with it.
I assume there is a cast or machined shoulder down there so everything must be pulled up? The manual calls for tool handle part # 327693
Does anyone know what diameter the puller end should be?