Steven Winters
New member
I'm new to this thread and see great information everywhere but nothing specific about what to do through the troubleshooting guide. I just picked up this boat and motor and have no spark. Following the troubleshooting guide:
Now is the problem the stator or the flywheel magnets? Thank you in advance for any of your help!
- Disconnect the black yellow kill wire and retest. If the engines now has fire, the kill circuit has a fault-possibly the keyswitch, harness or shift switch. ------ NO SPARK
- Check the stator resistance. You should read approximately 500 ohms from the brown wire to engine ground. -------- GOT 492 OHMS.
- Check the DVA output from the stator. You should have a reading of at least 150V or more from the brown wire to engine ground (while connected to the pack). ------- GETTING 476 mV!!!! BUT I CONTINUED ON.
- Check the timer bases resistance from the black/white wire to the white/black wire. Reading should be 10-20 ohms. ------ GOT 16 OHMS.
- Check the DVA output from the timer base. A reading of at least 0.5V or more from the black/white wire to the white/black (while connected to the pack) is needed to fire the pack. ------- GOT 0.45V AND I DIDN'T TRY THE TIMER BASE ADJUSTMENT YET.
Now is the problem the stator or the flywheel magnets? Thank you in advance for any of your help!