Logo

Trying to replace bottom Piston on a 1975 Johnson 75 hp motor need help...

davidgauldin

New member
Question:
I am trying to replace the piston on my Johnson 75 hp motor. The problem I am having is the front cylinder half will not come loose at the bottom . I have removed all the screws that I can see the top is loose but not the bottom . I can not figure out what is holding me back.. Is there something else I need to remove to get this off? Thank you
 
You must remove the entire engine block from the exhaust housing.----Sounds to me you are looking for a shortcut , and there are none.
 
You must remove the entire engine block from the exhaust housing.----Sounds to me you are looking for a shortcut , and there are none.

Thank you Racerone this is what I was thinking and was hoping you would be the one to reply.. Your help is very much appreciated..... You always steer me in the right direction...
 
Back
Top