Logo
FULL SITE MENU

(Twin controller for 225HP's) 4 adjustment screws with lock down nuts

B

bmw332is

New member
Under the dual control cover there are 4 lock down nuts each one has an adjustment screw (they are not the 2 friction adjustments for the levers)... these are on top of the metal control box...what are these??

I can not find them mentioned or noted in the operations manual?
 
Last edited:
One is the full throttle stop adjustment bolt and the other is the reverse throttle stop. These normally are not adjusted unless the control is used on a BF25 - Bf50 or the control is physically installed backwards (for one reason or another - then there is also a lot inside of the box that has to be changed - not recommended).

There is a set on the port and a set on the starboard shifter.

Mike
 
I'm trying to do most of it myself but I am in a little over my head.Have you read my low compression thread? Got Virgil from A+ MOTORS on A1A in Stuart coming to my dock this afternoon.I was an Evinrude test boat driver 26 years ago and got a lot of exposure to outboards and boats.
 
Just read the thread...keep us posted on what you find out. You are certainly over my head with all 6 cylinders reading low compression on the one motor...good luck!
 
Back
Top