island_boy
Contributing Member
Thanks for your reply regarding my outdrive issue. The end caps did not leak any water and I made sure the gasket and plates were installed properly along with the cork and rubber o ring seal that sit on the on the trunion of the outdrive. I know if you install them improperly you get no circulation. I did have circulation for about 15 minutes and then all the crap started with no water circulation. As for the grease zirt in the front of the drive, I see a plastic plug in the area you mentioned. I think it is threaded, is this the location of the grease zirt,under that plastic plug? Thanks so much for your reply, As I mentioned this outdrive sat in my garage for 2+ years,could the time sitting have been a factor in the waterpump failure? Or could the mechanic who did the work done the installation improperly? Also, what are the symtoms of a weak or failing fuel pump?