talkwitdave
Member
Hi there. My cobra drive will shift into reverse but not forward. With the drive in neutral I
measured the shift rod height from the housing surface to the top of the shift rod head and I get 7 inches.
The manual says it should be 7 13/64". Is it OK to back off the locknut underneath the shift rod head and turn the shift rod to get it to the correct height or do I have to separate the upper and lower drive housings so I can turn the shift rod and head together. Thanks
measured the shift rod height from the housing surface to the top of the shift rod head and I get 7 inches.
The manual says it should be 7 13/64". Is it OK to back off the locknut underneath the shift rod head and turn the shift rod to get it to the correct height or do I have to separate the upper and lower drive housings so I can turn the shift rod and head together. Thanks