I have a 27 Formula SR-1 on a 32' Load Rite Trailer with rollers. The rollers are set on 2 pivot points. My skeg has about 15” to ground clearance, lowest point in the stern is 18”. The bottom of the bow sits about 27” above ground clearance.
I’ve had the boat for about 4 years and I don’t think it was ever trailored much. I have to back my truck rear axles into the water, each time I load and unload. I’m wondering if there is some kind of lowering kit ( for the rollers and pivots) for the trailer, to make it easier to launch? Looks like I can take it down about 6 inches in the front, but it is already on the lowest points. Any suggestions short of a different trailor?
I’ve had the boat for about 4 years and I don’t think it was ever trailored much. I have to back my truck rear axles into the water, each time I load and unload. I’m wondering if there is some kind of lowering kit ( for the rollers and pivots) for the trailer, to make it easier to launch? Looks like I can take it down about 6 inches in the front, but it is already on the lowest points. Any suggestions short of a different trailor?