Logo

1976hydroswift transom seal replacement

1976Hydroswift

New member
Is it difficult to replace a transom seal on a 120hp OMC stern drive. I have a small crack on the top. I did seal a small hole on the bottom of the seal with silicone it seems to be working. I know sooner or later I will have to replace the entire seal. Do I need to bring this to a boat service station or can I do it myself.
 
most would consider it a DIY job. 3 hours tops.
never rely on silicone to keep a boat floating
 
you need to count the screw holes and get the same one . Put the drive halfway up.

Then take the old one off, and scrap the hull. Install the new one and use 4200 or 5200 .

seal the screw heads, and your done let it dry.
 
Back
Top