I want to replace my water pump but can't figure how to disconnect the shift rod.
Schematic shows a clamp on the middle of rod in the lower unit. I do not see an access to the clamp holding upper and lower sections. There is a hole under the lower vibration bracket but no break in the rod inside.
Do I need to start at the shift lever under the carb ad disassemble top down?
Thanks for you assistance,
Uncle Mike
Schematic shows a clamp on the middle of rod in the lower unit. I do not see an access to the clamp holding upper and lower sections. There is a hole under the lower vibration bracket but no break in the rod inside.
Do I need to start at the shift lever under the carb ad disassemble top down?
Thanks for you assistance,
Uncle Mike
Last edited: