Bildge pump switches

I recently upgraded my dash with new switches. I am having trouble figuring out the bildge switches. I have a mid bildge and aft bildge. Both have float switches. The switch on the dash has "on" "off" "auto" positions. There is a small led light on the panel on each side of the switch to indicate when it is pumping; yellow led on the left for "on", red led on the right for "auto". On the back of the each switch is 6 tabs and two wires for each led light. I only have two brown wires for each switch from the bus bar. How do I wire these switches?

Is the float switch integrated with the pump?

Yes, there is a float switch next to each pump.

Do you have a meter to test continuity? I can guide you how to wire the system. We need to check the circuit diagram on the switches or do they have one printed already?? The leds should have a resistor wired in series , if they don't, they are ready to connect, piece of cake.