Logo

1988 johnson 120hp VRO

turmain

New member
I have a 1988 Johnson 120 VRO and the VRO went south, so I installed a new fuel pump on it with out the VRO cause I was premixing anyway. My problem is now the motor is stuck in limp mode (2500 RPM max). All sensors test good, new power pak, new stator, and new timer base installed and still in limp model. Cannot figure out the problem unless it is the purple wire for low oil causing the limp mode. Can anyone help
 
Re: 1988 johnson 120 VRO

you did disconnect the 3 wire or 4 wire plug from the vro right.
did you remove the oil tank from the system?
have you tested the horn on your control box to make sure it works?
are there any alarms going off,
 
Back
Top