delsolracing
New member
I have been hunting around for a answer to this and am ready to pull my hair out.
I have a 84 DT115 and my tilt/trim gauge is out. I have tried searching for a replacement and there are none to be found anywhere.
I have a four wire sending unit and all of the gauges I can find are for a two wire gauge. I am to the point where if I have to buy a two wire sending unit I will look into it but I would like to find one that will install without to much fabrication.
So here are my questions finally. Does anyone know where I can find a gauge for this unit? Does anyone know of any way to wire something up to make a two wire gauge work with a four wire sending unit? And finally is there a two wire sending unit that will bolt up fairly easily to this motor so I can use a modern gauge?
Any help is greatly appreciated!!
I have a 84 DT115 and my tilt/trim gauge is out. I have tried searching for a replacement and there are none to be found anywhere.
I have a four wire sending unit and all of the gauges I can find are for a two wire gauge. I am to the point where if I have to buy a two wire sending unit I will look into it but I would like to find one that will install without to much fabrication.
So here are my questions finally. Does anyone know where I can find a gauge for this unit? Does anyone know of any way to wire something up to make a two wire gauge work with a four wire sending unit? And finally is there a two wire sending unit that will bolt up fairly easily to this motor so I can use a modern gauge?
Any help is greatly appreciated!!