I just rebuilt twin AQ145s after one shattered a valve shim. Both back together;
port eng- starts but won't keep going....seems starved for fuel, pumping throttle can save a stall, but I can't get it to run smooth. New gas, carbs rebuilt, adjustments as per manual, 1 1/4 turn on mix screw, accelerator pumps working.
Stbd eng- No spark. Timing light on coil wire is dead, won't start.
I replaced rotor, cap, coil, Spark plugs and wires. Reset gap and advance, 10degrees on both engines.
There is power at the coil, but nothing to the distributor. Any ideas?
port eng- starts but won't keep going....seems starved for fuel, pumping throttle can save a stall, but I can't get it to run smooth. New gas, carbs rebuilt, adjustments as per manual, 1 1/4 turn on mix screw, accelerator pumps working.
Stbd eng- No spark. Timing light on coil wire is dead, won't start.
I replaced rotor, cap, coil, Spark plugs and wires. Reset gap and advance, 10degrees on both engines.
There is power at the coil, but nothing to the distributor. Any ideas?