"I have been working from the
"I have been working from the bow to the stern on this rebuild. I have rebuilt the Upper gear house and began on the lower drive.
The outdrive is a MC-1 with the pre-load pin. On the drive shaft just above the water pump house is an o-ring. When assembling the two cases will this o-ring slide past the lower seal in the upper gear house? From the wear marks on the shaft the o-ring groove is clearly above the lower seal.
Any general tips on assembling these two very important items?
Regards,
TxGalz Dah"
"I have been working from the bow to the stern on this rebuild. I have rebuilt the Upper gear house and began on the lower drive.
The outdrive is a MC-1 with the pre-load pin. On the drive shaft just above the water pump house is an o-ring. When assembling the two cases will this o-ring slide past the lower seal in the upper gear house? From the wear marks on the shaft the o-ring groove is clearly above the lower seal.
Any general tips on assembling these two very important items?
Regards,
TxGalz Dah"