"Hi all,
think I have done
"Hi all,
think I have done the universal joint in the stern drive. I have the workshop manual and I am in the process of removing the leg, but have come up against a problem.
I have removed the 6mm lock screws for the hydralic pivot but cannot remove the pin. Is there a trick to removing this pin? Does this need to be pressed out?
Have applied plenty of wd-40 and even applied heat but doesn't even look like moving.
Any suggestions appreciated as I cannot remove the leg till I resolve this.
Paul"
think I have done
"Hi all,
think I have done the universal joint in the stern drive. I have the workshop manual and I am in the process of removing the leg, but have come up against a problem.
I have removed the 6mm lock screws for the hydralic pivot but cannot remove the pin. Is there a trick to removing this pin? Does this need to be pressed out?
Have applied plenty of wd-40 and even applied heat but doesn't even look like moving.
Any suggestions appreciated as I cannot remove the leg till I resolve this.
Paul"