fishkiller62
New member
"I recently did some work on t
"I recently did some work on the lower end of my Nissan 90A to replace the impeller. After I trailered it home, the hydraulic trim isn't working? I can hear the hydraulic motor working when I press the trim button down, but the rods aren't retracting. The tilt portion is working fine, but when I continue to hold the tilt/trim button down, the motor isn't going down at all below the tilt position. I checked the manual release latch and its not stopping the motor from moving down. I would greatly appreciate some advice on troubleshooting this problem."
"I recently did some work on the lower end of my Nissan 90A to replace the impeller. After I trailered it home, the hydraulic trim isn't working? I can hear the hydraulic motor working when I press the trim button down, but the rods aren't retracting. The tilt portion is working fine, but when I continue to hold the tilt/trim button down, the motor isn't going down at all below the tilt position. I checked the manual release latch and its not stopping the motor from moving down. I would greatly appreciate some advice on troubleshooting this problem."