PDA

View Full Version : 03 ox66 225 please help



basserman1
07-10-2009, 07:05 PM
"I had to replace the high pressure pump about a month ago. The motor ran fine until the old pump died. The only thing I touched on the motor was the high pressure pump. Now, the motor will run for only 10 seconds. I have replaced the fuel filter, fuel bulb, and one of the low pressure pumps that leaked gas when I loosened the mounting bolts.

Now, all three pumps including the NEW low pressure pump leaks gas when I loosen the mounting bolts.

I cant get this thing to run. What else can I do?

Thanks!!"

tommy1
07-16-2009, 09:20 PM
"Our motor had a inline check valve that got stuck closed,trace the fuel line and see if yours has one if so remove it we did, another thing to look for is inside the VST tank the needle valve on the float got stuck close also i took it out and clean it off good and it has been working good for now, hope this helps.... (the check valve is passed the clear filter our came apart i removed the ball and put it back together)"