Logo

LU

richardkcmo

New member
After replacing the impellor i

After replacing the impellor in a 488 mercruiser the lower doesnt want to go all the way on.Is their a trick to this?
Richard
 
"turning the prop shaft till t

"turning the prop shaft till the splines line up,

watching where the water pipe is

making sure the shift shaft lines up"
 
"The only other thing that may

"The only other thing that may be holding you up (down), is the shift linkage. Ensure that both the shift lever and the shaft that it connects to are lined up (both in forward gear).Don't be too forceful. As Brian says, slight pressure on the prop to turn the drive shaft just a bit should engage the splines."
 
Back
Top