Omc cobralower unit

is there any link where i can

is there any link where i can get same info to remove the lower unit and replase theu-joint bellow and exhaust bellow

"I do not know of a link but c

"I do not know of a link but changeing the u joint and exhaust bellow on a cobra is pretty easy. remove the six nuts that hold the drive to the gimbal housing and remove drive unit.remove the snap ring in the exhaust bellow and remove exhaust bellow from housing, the ujoint bellow just snaps into the housing remove it from the housing. remove the plastic nut that holds the water tube in the housing then remove the two allen head bolts in the side of the gimbal housing and set housing aside becareful not to damage the shift cable. then loosen the clamps on the ujoint and exhaust bellows at the transom bracket and remmove. this would be a good time to check the gimbal bearing and shift cable. if there is any doubt change them better to do it now than to tear everything back apart latter. hope this helped you good luck. Michael"