Going back thru my engine yest
Going back thru my engine yesterday I pulled the distributor cap off and the metal tab on the rotor button was bent to one side. This is not the first time I've found that.It happened with the old cap and button. This one is new. The cap fits snuggly with no play. The button fits tight. The distributor shaft doesn't seem to have any play at least from trying to wiggle it. Any ideas on what might cause that? Seems to run fine. Its a reverse rotating LM318. Will a stock automotive distributor fit? It is not electronic...I'm thinking a warped shaft but have never heard of that happening.
Thanks
Going back thru my engine yesterday I pulled the distributor cap off and the metal tab on the rotor button was bent to one side. This is not the first time I've found that.It happened with the old cap and button. This one is new. The cap fits snuggly with no play. The button fits tight. The distributor shaft doesn't seem to have any play at least from trying to wiggle it. Any ideas on what might cause that? Seems to run fine. Its a reverse rotating LM318. Will a stock automotive distributor fit? It is not electronic...I'm thinking a warped shaft but have never heard of that happening.
Thanks