Logo
FULL SITE MENU

Paragon planetary gears

C

chris_holt

Contributing Member
"I have one of my pv33 transmi

"I have one of my pv33 transmissions torn down for a rebuild, and was forced to take apart the planetary set. I am curious if anyone has any tricks for re-assembling the two hundred or so needle bearings that fall out of them...Chris"
 
"Thats the trick is it? Would

"Thats the trick is it? Would you use a heavy wheel bearing grease, or a lighter chassis grease. The main issue is that you can not install one gear at a time, they must all be in place first so you can drop the input shaft in the centre, then begin tapping the six pins through without knocking any of those little varmits out. Sounds like you need to be in a patient mood before starting this project!...Chris"
 
Back
Top