"Ok... '73 silverton with
"Ok... '73 silverton with twin 318's. I'm replacing plugs, points, condensor, coil resistor, and plug cables. I have a feeler gauge and a timing light. I have timed motor with timing light but it's been quite a few years.
What is the correct gap for points? I used .035 for the plugs.
And for timing? I did not look yet to see if TDC is marked so I may need a reminder how to find it. Also I forget how to properly time motor. What are the proper settings? Another post here describe this?
Think I should go ahead and replace coils as well?
Thanks again in advance - David"
"Ok... '73 silverton with twin 318's. I'm replacing plugs, points, condensor, coil resistor, and plug cables. I have a feeler gauge and a timing light. I have timed motor with timing light but it's been quite a few years.
What is the correct gap for points? I used .035 for the plugs.
And for timing? I did not look yet to see if TDC is marked so I may need a reminder how to find it. Also I forget how to properly time motor. What are the proper settings? Another post here describe this?
Think I should go ahead and replace coils as well?
Thanks again in advance - David"