View Full Version : Cooling water for PSS Dripless shaft seal from sportpac 350
09-27-2006, 11:58 AM
I have the Marine Power Sportpac 350. I am looking for a location to install a fitting to cool my PSS Dripless shaft seal.
Has anyone done this ?
09-27-2006, 06:01 PM
"If it is FWC you can come off of the currently plugged fitting in the bottom of the heat exchanger, if it has one. Make sure you plunge out the port to clear any scale which may be blocking it and flush it good. If RWC, come off of the bottom of the exhaust manifold, same thing goes for flushing this port."
09-28-2006, 07:40 AM
Thanks for the info. It is FWC so I'll use the heat exchanger.
09-28-2006, 08:11 AM
"Bill, Just make sure it's a raw water port, some exchangers have both."
09-28-2006, 11:46 AM
Ok will do. Thanks
09-29-2006, 07:39 PM
I had PSS installed recently. The cooling line was run from the starboard drain plug on the forward heat exchanger. Engine temps didn't change.
Powered by vBulletin® Version 4.2.3 Beta 3 Copyright © 2015 vBulletin Solutions, Inc. All rights reserved.