PDA

View Full Version : Kad 43 compressor clutch slipping



antsinupants
04-19-2009, 06:35 AM
I have a Kad 43 i have replaced the complete compressor clutch and belt.
but i still have a slipping clutch
I have adjusted the running clearance of the pully faces. the belt is tight.
i think it is not getting enough power to the magnet? any ideas how to check the output to the magnet?
also what controls the compressor?
many thanks rob

vosman
04-20-2009, 10:10 AM
Can you rotate compressor by hand? Must spin freely or just slight drag. Unit is controlled by a relay box under cover and an rpm sensor above raw water pump.

antsinupants
04-20-2009, 06:25 PM
thanks for the reply
i have now replaced all the belts. things are all good now. the small belt that takes drive from the crank was worn out.