"Help! I have this engine in 2
"Help! I have this engine in 28 foot Harris Kayot Pontoon, very little room to work in the dog house...My concern is that it takes several revolutions of the engine for the motor to start, they tell me that I need "X" pounds of oil pressure to kick in the electric fuel pump. I hate to think of replacing a starter, probably would have to pull the engine...Why won't my motor start right up, is gas bleeding back down from my carb, I have taken the fuel pup off and it does not appear to allow anything to bleed back through it...will it hurt anything if I bypass the oil pressure sending unit that runs juice to my fule pump so when I hit the key the fuel pump would run gas to my carb...that would make it start imediatley ...when I shoot some gas in the carb and hit the key it fires right up...would I screw up any on board computer if I were to by pass that sender.....any ideas or suggestions."
"Help! I have this engine in 28 foot Harris Kayot Pontoon, very little room to work in the dog house...My concern is that it takes several revolutions of the engine for the motor to start, they tell me that I need "X" pounds of oil pressure to kick in the electric fuel pump. I hate to think of replacing a starter, probably would have to pull the engine...Why won't my motor start right up, is gas bleeding back down from my carb, I have taken the fuel pup off and it does not appear to allow anything to bleed back through it...will it hurt anything if I bypass the oil pressure sending unit that runs juice to my fule pump so when I hit the key the fuel pump would run gas to my carb...that would make it start imediatley ...when I shoot some gas in the carb and hit the key it fires right up...would I screw up any on board computer if I were to by pass that sender.....any ideas or suggestions."