pkuptruck007
New member
"thought I posted here earlier
"thought I posted here earlier...but I dont see it! SO here it gors again...
I want to fix this beast, while it is still below freezing here in Michigan... LOL
I noticed it is leaking oil by the cavitation plate, and before I put it away last fall, it was spewing a grey oil out of the exhaust post. Even I know that aint a good sign.
So, which seals do I need to fix? Or should I just do them all? Would this grey stuff indicate a bad impellor? Or something else?
What tricks or tips do you have to make this painless? LOL
Also, I noticed a thread about the ATOM solid state ignition gizmos. Supposed to replace the points and condensor or something... And, I ran across something like it on Fle-ebay. And wondered.... would this be a PLUS or a MINUS for this little gem of a motor?
thanks in advance for any responses!
matt
Michigan"
"thought I posted here earlier...but I dont see it! SO here it gors again...
I want to fix this beast, while it is still below freezing here in Michigan... LOL
I noticed it is leaking oil by the cavitation plate, and before I put it away last fall, it was spewing a grey oil out of the exhaust post. Even I know that aint a good sign.
So, which seals do I need to fix? Or should I just do them all? Would this grey stuff indicate a bad impellor? Or something else?
What tricks or tips do you have to make this painless? LOL
Also, I noticed a thread about the ATOM solid state ignition gizmos. Supposed to replace the points and condensor or something... And, I ran across something like it on Fle-ebay. And wondered.... would this be a PLUS or a MINUS for this little gem of a motor?
thanks in advance for any responses!
matt
Michigan"