Logo

Gauge replacements 1987 Ebtide 180 w 37L 165

vkeiper

New member
"My tach, voltage, and MPH gau

"My tach, voltage, and MPH gauges are shot.

Will most gauge kits work for this application or do I have to go through Ebtide?

Or do most gauge kits have you replace the sending units (Oil Pressure, Water Temp< Fuel)?
I am sure if I try Ebtide they would match up, but I am also sure they cost a heck of alot more too.

Any good vendors you recommend to find replacements?

Thanks,
Vince"
 
"I'm not doubting your dia

"I'm not doubting your diagnosis but you may want to check the wiring and senders on the engine before replacing the gauges. For the speedo, clear out the hole in the front of the stern drive with a small drill bit or something (use your hand, not drill). Also, check the hose connection half way up the stern drive closest to the transom. Speedo works off water pressure. If you ground the gauge wire, they should peg out. This will eliminate the gauges as being faulty in most cases."
 
I Just replaced the fuel ga on

I Just replaced the fuel ga on my Ebbtide Monterey
They seem to be pretty standard 35-240 ohm. Just about anything from the marine shelf should work!
 
Back
Top