Logo

Water flow problem

coldbay

New member
"I have a 1989 4.3L Mercruiser

"I have a 1989 4.3L Mercruiser. While flushing the motor I only get 1/2 the flow of water out of the right exhaust when comparing each side. Cold or hot. I took off the exhaust manifold and elbow, both are rusty. Cleaned out the best I could but still same problem. Also checked butterfly in exhaust pipe, checked good. Before I go out and replace the manifold and elbow should I check something else. Could I remove those balls at the thermostat housing to see if that is my problem? Boat has been run in salt water so there is a lot of rust internally. Any help would be greatly appreciated, John."
 
"First of all, go out and by y

"First of all, go out and by yourself (here I go again!) a laser-pointed temperature gage (30 bucks at Harbor Freight). Then sweep across the entire motor to see where/ if you have hotspots. Guessing can only lead to a waste of effort and $$$ on what might be a non-problem.

Jeff"
 
Back
Top