View Full Version : 2003T turbo
10-15-2008, 04:13 PM
I have a 2003t and could not get full revs found problem was turbo stiff (removed air filter found 8mm nut on end of shaft not tight can I just remove compressor housing to check no pick up before trying engine
11-03-2008, 04:19 PM
"HONDA 225 four stroke, replacing water pump, outdrive slid down 3 1/2" then stopped, used BFH and a block of wood did not move, then used a porta power and BFH won't budge ? any ideas?"
11-18-2008, 08:02 PM
You need to post on the Honda outboards forum, they will have the answers you need."
11-18-2008, 08:05 PM
What do you mean to check no pickup??? You can remove the compressor housing, was it the nut on the turbo shaft itself loose (the one that holds the compressor wheel)? If it was there is a chance the compressor wheel has turned on the shaft and has gone out of balance. Balance is very critical at 170000 rpm."
Powered by vBulletin® Version 4.2.3 Beta 3 Copyright © 2014 vBulletin Solutions, Inc. All rights reserved.