rellis1962
New member
"Hey guys,
I am new to the fo
"Hey guys,
I am new to the forum. I have a question about converting my 1987 Ski Centurion Tru Trac II from points to electronic. I have a 351 w/ prestolite snap down dist. I purchased the Sierra 18-5288 conversion kit and installed it. I had to CCW Retard? the timing considerably to get it to idle smooth. I also noticed that the rotor is a very loose fit (it wiggles quite a bit) on the nub it fits on. The engine seems to run Ok but have not had it out on the water yet. I tend to think that that wiggle is not a good thing as the old rotor is a tight fit. The old rotor will not fit in the magnet sleeve nearly as neatly as the rotor that came with the kit. Did I get the wrong conversion kit?"
I am new to the fo
"Hey guys,
I am new to the forum. I have a question about converting my 1987 Ski Centurion Tru Trac II from points to electronic. I have a 351 w/ prestolite snap down dist. I purchased the Sierra 18-5288 conversion kit and installed it. I had to CCW Retard? the timing considerably to get it to idle smooth. I also noticed that the rotor is a very loose fit (it wiggles quite a bit) on the nub it fits on. The engine seems to run Ok but have not had it out on the water yet. I tend to think that that wiggle is not a good thing as the old rotor is a tight fit. The old rotor will not fit in the magnet sleeve nearly as neatly as the rotor that came with the kit. Did I get the wrong conversion kit?"