View Full Version : AD41B sequence for valve clearance check
09-05-2008, 05:51 PM
Could anyone tell me the correct sequence to check the clearances please. I am also trying to find a workshop manual for this if you have any suggestions thanks in advance.
I can point you to the owners manual but not a workshop manual I am afraid.
If necessary you can turn the engine until a valve is fully open and then turn it one complete turn to the check/adjust position.
Repeat for each valve in turn but that's lot of engine turning! That may be how the manual says to do it anyway.
Clearances are 0.4mm / 0.016" cold.
Does anyone know where i can get a workshop manual for a volvo penta AQAD41B DP.Thanks
I would like to know what engine rpm and what psi reading is required to test off the manifold.
11-05-2008, 06:36 AM
Sent you an email.
Powered by vBulletin® Version 4.2.3 Beta 3 Copyright © 2017 vBulletin Solutions, Inc. All rights reserved.