alright replaced the bellow an
alright replaced the bellow and the gimbal bearing on my 1986 3.0 but for some reason i can get it all the way on up to about a inch and a half then it it just wont get on ... cleaned the splines on both drive shaft and where it connects into the engine i pressed the gimbal bearing in as well but it seems as if the inside of the gimbal bearing is getting resistance from the drive shaft since the drive shaft is kind of tappered?
Question does the drive shaft also be compressed on to the gimbal bearing aswell if so how .... or any other suggestions
alright replaced the bellow and the gimbal bearing on my 1986 3.0 but for some reason i can get it all the way on up to about a inch and a half then it it just wont get on ... cleaned the splines on both drive shaft and where it connects into the engine i pressed the gimbal bearing in as well but it seems as if the inside of the gimbal bearing is getting resistance from the drive shaft since the drive shaft is kind of tappered?
Question does the drive shaft also be compressed on to the gimbal bearing aswell if so how .... or any other suggestions